Cars Comp

BMW LCD COMMUNICATIONS INSTALLATION MANUAL

BMW LCD COMMUNICATIONS-INSTALLATION GUIDE

When you have set up a permanent location for the source of the alarm control unit and battery, as defined in the door switch to the vehicle type, you must specify the source is CONNECTED to a 12 volt power. This source is generally found on the flow switch wire harness and shows constant voltage, when the key is in the "on" and with the engine running. This voltage source must be removed, when the engine and ignition "OFF". When you configure a switched 12 volt source, look for parking the vehicle and leaving the lights on the wire. This wire is usually used for the light switch to the back or some handy light is installed in the vehicle, which is easily under the hood in front of the hotel. The correct wire displays voltage, when the light switch is turned on the lights in the parking place. If this installation instead of a siren, the vehicles Horn to honk the Horn line fuse block or Search the main harness fuse block.

VEHICLES, IT IS RECOMMENDED THAT YOU TAKE ADVANTAGE OF THE HIGHLY TECHNICAL NATURE OF THE VOLTMETER TO CHECK ALL ELECTRICAL CIRCUITS, OR FOR MAKING CONNECTIONS TO THE VEHICLE INSTEAD OF COMMON TEST LIGHT! Test the lights can cause damage to the vehicles computer if the wrong wires are asked and can result in air-bag systems to activate (use). Either the above cause extensive damage to the vehicle, which reads. Pay attention to all Warning labels on the vehicle. Automatic page creation assumes any liability to the account holder in this or any other vehicle or personal injury caused by improper installation damages. Professional installation is recommended for RF-520-security system. For details, see the limited lifetime warranty.

Download here