Tuesday, May 28, 2013
Tilting the car with his hands
Many motorists, particularly those from older generations, prefer to repair their vehicles themselves. If minor damage can be pretty easy to fix in your own garage, the work associated with repair of the body or chassis, require additional equipment. Take, for example, dump the car. Buying a factory unit did not benefit the ordinary motorist, as it is used quite rarely, but worth a decent amount. At the same time, the need to use it in some papers is required. So how do you get out of this situation? There are many authoring road tripper, which is made by hand. They vary in design but have the same goal - to facilitate working conditions in a serious car repairs, not investing at the same time in the manufacturing of the devices a significant amount. Immediately I must say that looking at some construction, the first thing to pay attention to security that delivers a product with its use. There are quite a simple system, but the use of many pretty traumatic. For example, Tilting, made of wood material. In such designs is difficult to achieve stable stability of the device and given duty. Even if made on such drawings dump confident enough to work now, then after a while, with the aging of the wooden parts, its use can lead to accidents. Should give preference to those devices that are completely exclude spontaneous sinking car. This is achieved by mounting a serious enough tilt to the floor of the garage and the car. It is advisable to be at least three contact points, one of which falls on the opposite side of the lift side. This design dramatically reduces the risk of "backsliding" of the machine under mechanical impact and shearing it from blocking elements. When choosing a system tilt is useful to consider not only the capacity but the number of people that can help you raise the car. If you use a jack or a special lift system, this question is usually not necessary. Another important characteristic is the angle to which the design allows to lift one side of the car. Of course, it is sometimes quite a bit "bully" the machine to perform a certain job, but if you look more far-sighted, then a greater degree of uplift is always preferable. And in conclusion, that the manufacture of tilt to thoroughly work out the technical documentation design and try to follow closely the recommendations of the developer. If there are restrictions on the use of certain materials, it is reasonable to consider them or to apply more sophisticated. Of course, this should not limit your imagination and rationalization idea, but it is easier to improve an existing product than to start from scratch.
